Mirror -BGM PRO, Ø=105mm- Vespa V50, 50N, PV125, ET3, Rally, Sprint, PX, Super, TS125, GT125, GTR125, GL150, SS180 - black, left hand side

Mirrors from BGM PRO for mounting the handlebars on classic Vespa scooters

The BGM PRO mirrors have an ideal ratio between arm length and mirror surface. With a mirror surface of only 95mm, the optics harmonize perfectly with classic shifting scooters. The length of the mounting arm was dimensioned (250mm) so that a perfect view to the rear is always given. It protrudes only minimally over the lateral contour of the scooter. Thus the practical suitability remains fully maintained, even if it is sometimes tight...

STABLE
The mounting arm has a stable 10mm diameter. This makes it very low-vibration, which is further enhanced by the small and lighter mirror head. A good view is therefore guaranteed even if the engine vibrates.

ADJUSTMENT
The mirror adjustment works permanently and pleasantly taut, whereby the mirror always remains in the once adjusted position and does not adjust itself. The adjustment range is pleasantly wide*.

Scope o
f delivery The BGM PRO mirror is delivered ready for installation with an M10 thread including counter and fixing nut. An M10 washer and corrugated washer are also included.

VERSIONS
The mirror is available in a high-quality chrome plating or a satin matt black coating.

MOUNTING
A mounting plate for the handlebars is required for mounting. We recommend the holder from RMS (3330807, see also accessories). The enclosed screws have a sufficient length for the Vespa PX models. For Rally/Sprint we recommend screws with the dimensions M8x25mm.

NOTE
*Epending on the vehicle/installation situation it may be necessary to bend the holder in the front area of the mirror mount slightly downwards or alternatively to bend the holder plate by a greater distance at the front (washer(s) between plate and handlebar).

CONCLUSION
Perfect all-rounder in high quality