Wheel bearing housing puller plate WALLMEK 3 and 4-bolt 18t and 22t cylinders

For pulling out 3- and 4-bolt wheel bearing housings without needing to remove the drive shaft. For use with an 18T or 22T cylinder. VW, Audi, Seat, Skoda, Subaru, etc. Bolted bearings often become heavily seized in steel or aluminum steering knuckles. The old hub often needs to be reused with the new bearing, so it must be removed. This tool is designed for quick work directly under the vehicle. Often, it is not necessary to remove the end of the drive shaft from the hub. To remove the hub, an additional tool, 01-00040 or 01-00049, is required. Using the old bearing frame bolts and the included washers, attach the plate to the bearing frame. Use tool 01-00026, 01-00047, or 01-00027 to press out the bearing. An 18T or 22T hydraulic cylinder, or a 1064 slide hammer, is required.