HEPCO&BECKER Nova LED auxiliary headlight set Ø25-32mm crashbar mount

With the Nova LED auxiliary light set from HEPCO&BECKER, you get everything you need to improve the visibility and safety of your motorcycle. The set contains powerful LED auxiliary lights, a universal mounting set, a cable set, a switch, instructions and a tool set for convenient installation and control.

The Nova LED auxiliary lights provide improved road illumination and give your motorcycle an attractive look. Easy installation is made possible by the included universal mounting and cable sets.

• High-power LEDs with two switching levels at 2,500lm - 4,350K / - 5,500K
• 12 volts, 25 watts per headlight
• ECE tested and approved, therefore no individual approval is required (observe country-specific legal regulations for installation)
• Improved visibility in traffic
• Universal attachment to engine or tank protection bars with tube Ø25mm – Ø32mm; can be attached standing or hanging
• Complete headlight set: 2x LED auxiliary headlights, 1x switch, 1x cable set, 2x clamps including reducing sleeves, 1x instructions, 1x tool set
• Connection is only via the battery; no connection to the vehicle wiring harness is required
• No external operation by third parties, thanks to a special control unit with automatic voltage control
• Waterproof and dustproof to IP67
• Headlights can be flexibly switched on using the switch on the handlebars

Note: The lights can only be switched on approximately 5-15 seconds after the engine has been started. A voltage of 13.1 V must be applied to the control unit of the wiring harness to enable the circuit. In older vehicles, this can be achieved by briefly increasing the engine speed. Switching off must be done manually using the switch. The NOVA LEDs continue to light up until the voltage limit of 11.8 V is reached, even after the engine is switched off. Only when the voltage falls below this limit do the lights switch off automatically via the control unit. When switching on again (wait for the time limit of the control unit), the voltage limit of 13.1 V is queried again.

Ø25-32mm Crashbars | universal attachment